Soy Wax Eco Pillar - 1kg

Preparation:

Ensure that you work on a safe surface, the selected pillar candle wicks (LX RANGE) are firmly in place, and that the max fill line have been market with a non-permanent marker to ensure that the moulds are not over filled.  Please follow the mould preparation methods available on each of the mould products.

NOTE – Natural waxes tend to require a larger wick size, ie wicking up to a larger size.

Lay down a few newspapers, as pouring candles can sometimes be messy.

Step 1 – Melting

• Wax should be melted in a Bain Marie double pot and should not be exposed to direct heat.
• Melt your wax over a low heat slowly to reach between 75℃.  The wax should appear slightly dark-golden in colour
• Take care not to heat over 80℃ as this can influence the setting and performance of the wax. Overheated wax is opaque in colour and can result in injury. It can also cause discolouration in the final product.

Step 2 – Adding Colour and Fragrance

• Add fragrance at 63 – 64℃ and stir gently for a minute. (Almost right before pouring the candle)
• If adding colour, we advise to add it before the fragrance to ensure that the colour blends well with the wax, at a slightly higher temperature as to blend in completely.

Step 3 – Pouring & Topping ( if topping is required )

• Once your fragrance and colour has blended, and the wax has cooled down to approx. 60℃ it is ready to be poured.  The wax will have a slight cloudy appearance, but mostly clear.  If the wax is too cool, it will create cavities in the way when drying the first pour. Fill the container and leave 1cm at the maximum filling line for the top-up.
• This wax is formulated to require only a single pour, in larger pillar moulds, a top up is needed to achieve a flat surface on the candle base. Warm up the remainder of the wax using a small Bain Marie to 60-63℃ – slightly warmer than the initial pour.
• It is important to have the containers at the same temperature as the ambient room temperature.
• (Pouring a top up, once the candle has cooled can result in a reduction of good adhesion to the pillar mould)

Step 4 – Curing

• Allow wax to cure for 12-24 hours before de moulding.
• Wait at least 48 hours before burn testing.

Step 5 – Test Burn

• Always double check your selected wicks and keep a record of which one was used.  Test the candle for burn pool diameter and possible mushrooming.  Using your notes as a guide try different wick sizes for the ideal burn and clean flame.